27
8.3. The castor axle
Having made adjustments to the rear axle, be sure to adjust the castor height and angle accordingly.
When carrying out these adjustments, it is important to bear the following points in mind:
•
The castor axle should stand at a right angle to the ground.
•
The castor should always remain in contact with the ground.
•
In the uppermost standing position, the leg supports must be resting on the ground.
•
Bring the
LEVO
active-easy
into the standing position.
•
Unscrew and remove the cylindrical screws using a 4 mm Allen
key, then set the plastic leg plug either higher or lower so that
the leg supports are standing on the ground. You may have to
turn the leg plug by 90°. (se photo 3).
•
Unscrew the two cylindrical screws using a 5 mm Allen key and
turn the eccentric disc until the axle is sitting vertically (see
photo 4). You may have to turn only one of the two eccentric
discs. Screw the cylindrical screws tight.
8.4. The leg supports
The leg supports should be replaced when the seat height of the wheelchair has been so greatly
adjusted that they no longer reach the ground or reach the ground too soon in the uppermost
standing position.
•
Remove the rear wheels (see Instruction Manual, section B.1.)
•
Remove the footrest (see section 8.6.).
•
Loosen the cylindrical screws on both inner sides of the leg
supports and remove them together with the spacer bushing (see
photo 5). Then pull the leg supports out of the frame.
•
Replace the leg supports and reassemble in reverse order.
3
5
4
