Leviton A7810, Installation And Operation Manual

Page: 14 / 44

11
6 EMB HUBLITE ADMINISTRATION OVERVIEW
6.7
Decide upon a method of data transfer (see section later in this document). If you select the
HTTP/Post method to send data to the BMO website, you can con figure this by selecting the
“LogFileData, Setup/Upload” page.
6.7.1
Make note of the EMB HubLite serial number.
6.7.2
Select upload options as needed for time of day to upload the data and retry control.
6.7.3
Check the checkbox to allow remote configuration. This will allow you to reconfigure the EMB
HubLite from the BMO web site without having to connect directly to the EMB HubLite.
6.7.4
Specify the “Target address to upload data.” This is the website address where the EMB
HubLite will send the collected data. If you have an in house data collection service, you
should enter the address of your data HUBLite in this field. Leviton also provides a service
called Building Manager Online that can collect and report data for you. If you are using the
BMO service, the target address to upload data should be set to
http://www.buildingmanageronline.com/upload.php
6.7.5
When configuring the EMB HubLite to send data to the BMO site or your own data collection
HUBLite , the EMB HubLite will authenticate itself with the HUBLite by using the serial number
and a password. This password must be supplied here, and can be obtained when you
subscribe for the BMO service, or by your database administrator.
6.7.6
Click “Apply” to save your changes.
If you select a manual transfer method, remove (blank out) the target address in the
Modbus/Upload Data page.
WEB
VERSION