WARNING
This device is intended only for lifting. The jack can be used only on a firm, level surface. Always
lock the wheels and apply the parking brake. Use additive supports for supporting the vehicle before
making repairs and other work under the car. Don´t overload the lift over its rated capacity. Before
lifting any vehicle, be sure the jack is in good condition. Do not set the pressure relief valve.
LIFTING THE VEHICLE:
1.
Make sure that the jack and the vehicle is on a firm, level surface.
2.
Always apply the parking brake and block the wheels.
3.
According to the car owner's manual to determine the lifting space intended to accommodate
the jack and place jack below this point.
4.
Turn the drain valve clockwise to the closed position. DON´T PULL!
5.
To lifting the vehicle to the desired position, insert the adapter into the control rod and pump
up and down.
6.
Place supports under the chassis to designated places by the vehicle manufacturer. Don´t be
under vehicle, if not on the supports. Jacks are not designed for long-term lifting heavy loads.
7.
SLOWLY turn the drain valve counterclockwise to start vehicle on supports.
LOWERING THE VEHICLE:
1.
Turn clockwise to close the drain valve.
2.
Lift the vehicle from the supports by pumping
3.
Remove the bracket. Don´t get under the vehicle while starting the vehicle.
4.
Release SLOWLY turning counterclockwise drain valve to launch vehicle floor.
CHECKING:
The product should be kept according to this manual. On this product should not make any
adjustments.
1.
Before each use should be visually inspected state, such as cracked welds, damaged, bending,
if missing or if they are damaged in some parts.
2.
The checking should be carried out according to the instructions in this manual.
3.
Check if cracked or broken some discord, if not present extensive corrosion if not allowed,
damaged or missing certain parts. Please note that some repairs may only be carried out with
special accessories and knowledge.
(see the point No. 4 in section Maintenance)
MAINTENANCE:
It is best to monthly adjustment. The lubrication is very important for the jacks, because they
carry a heavy load. Any dirt such as dust, dirt etc. can cause slower movement or very
severely damage internal components. The following procedure is designed for the correct
operation of the lift.
1.
Lubricate the lift cylinder, threads and pumping mechanism with light oil.
2.
Visually check if there are cracked welds, bending, damage or loss of parts or oil
leaks.
3.
The product should be immediately checked if it was subjected to excessive load or
impact.
4.
Once any hydraulic jack works abnormally, you should worry out of operation until
repaired by an authorized service agent.
5.
Keep all surfaces clean, labels and warnings.
6.
Check the oil level.
7.
Check the cylinder every three months if not found extensive corrosion. Clean it if
needed and wipe with a damp cloth with oil. When the jack is not in use should always
be lowered.
