6
Chapter 2
Chapter 2
Chapter 2
Chapter 2
Basic Setup
Basic Setup
Basic Setup
Basic Setup
This Chapter provides details of installing and configuring the FCS-0040/WCS-0040.
System Requirements
•
To use the wired LAN interface, a standard 10/100BaseT hub or switch and network cable is required.
•
To use the Wireless interface on the WCS-0040, other Wireless devices must be compliant with the IEEE802.11b,
IEEE802.11g or IEEE 802.11n specifications. All Wireless stations must use compatible settings.
The default Wireless settings are:
Mode: Infrastructure
SSID: ANY
Wireless Security: Disabled
Domain: USA
Channel No.: Auto
Installation - FCS-0040/WCS-0040
1. Assemble the Camera
On the WCS-0040, screw the supplied antenna to the mounting point on the rear.
2. Connect the LAN Cable
Connect the FCS-0040/WCS-0040 to a 10/100BaseT hub or switch, using a standard LAN cable.
For the WCS-0040, this will disable the Wireless Interface. The
Wireless and LAN interfaces cannot be used simultaneously.
Using the LAN interface is recommended for initial
configuration. After the Wireless settings are correct, the
Wireless interface can be used.
The first time you connect to the camera, you should connect
the LAN cable and configure the FCS-0040/WCS-0040 with
appropriate settings. Then you can unplug the LAN cable and
power off the camera. The FCS-0040/WCS-0040 will be in
wireless interface when you power on the camera again.
3. Power Up
Connect the supplied 12Vpower adapter to the FCS-0040/WCS-0040 and power up. Use only the power adapter provided.
Using a different one may cause hardware damage.
4. Check the LEDs
•
The Power LED will turn on briefly, then start blinking. It will blink during startup, which takes 15 to 20 seconds. After
startup is completed, the Power LED should remain ON.
•
The Network LED should be ON.
For more information, refer to Physical Details - FCS-0040/WCS-0040 in Chapter 1.
2
2
2
2
