Fehler! Formatvorlage nicht definiert.
13
When usin g ecardcs.exe Card Service Client Driver, only two option settings are
available: Interrupt and Base I/O Port. The default settings are IRQ 5 and Base I/O
Port 300. Other available settings are illustrated in the following table:
Option
Settings
Default
Interrupt (IRQ)
3, 4,
5
, 9, 10, 12, 15
IRQ 5
I/O Port
300
, 320, 340, 360
I/O 300
Table 3-1.2.1
Client Driver Option Settings
3.2 Installation
Before your computer system can recognize the EPC-0100TB, it is necessary to run
some software to enable it. This section gives a brief overview of the installation
process.
3.2.1 Installation Program
The EPC-0100TB comes with an installation program that allows you to automate
the installation task. We recommend using the install.exe program to make
installation as painless as possible. The install.exe program allows you to do auto
configuration, where the program automatically selects the most suitable option
settings, or do a custom configuration, where you individually select each optio n
setting.
3.2.2 Quick Installation
1.
Install your Card and Socket Services software to your computer. System with
Card and Socket Services allow the EPC-0100TB to configure itself
automatically by detecting available system resources and insert or remove
the card while the system is on. We call this feature “hot swappable”, thus
inserting or removing it while the host is on will not affect the system.
2.
You can run the install.exe program found on your Installation Disk. The
install program guides you through the installation process and help install
the network drivers needed to run the card on your network operating system.
