6400 West 105th Street / Bloomington, MN 55438 / www.problemsolversbike.com
MISMATCH IS II BRAKE TO SRAM
®
SHIFTER/DROPPER INSTRUCTIONS
THANKS FOR BUYING PROBLEM SOLVERS
MISMATCH ADAPTERS!
We’re always looking to provide the products that allow you to configure your
bike any way you want. So, if you wanted to mate your Shimano
®
Brakes with
a SRAM
®
shifter or dropper lever you’ve chosen the right product.
WARNING:
Cycling can be dangerous. Bicycle products should be installed
and serviced by a professional mechanic. Never modify your bicycle or
accessories. Read and follow all product instructions and warnings including
information on the manufacturer’s website. Inspect your bicycle before every
ride. Always wear a helmet.
WARNING:
Brakes are essential safety equipment to control and stop your
bicycle. It is therefore strongly recommended that you have this brake product
installed by an experienced professional bicycle mechanic. Failure to install
a brake system component properly may result in accident and serious injury.
For complete ASTM guidelines, and additional product safety information,
please visit problemsolversbike.com/safety
COMPATIBILITY & INTENDED USE
MisMatch IS II Brake to SRAM Shifter/Dropper will work with Shimano I Spec II
®
brakes and SRAM MatchMaker compatible shifters and dropper levers.
Intended for ASTM 3 conditions. This is a set of conditions
for the operation of a bicycle on a regular paved surface,
unpaved and gravel roads and trails with moderate grades
with irregular terrain where loss of tire contact with the ground
may occur. As well as rough trails and unimproved trails that
require technical skills. Jumps and drops are intended to be
less than 61cm (24”).
INCLUDED PARTS
A. IS II Brake to SRAM Shifter/Dropper (1)
B. M5x0.8-8L, Bolt (1)
TOOLS REQUIRED
4 and 5mm hex wrenches
T25 Torx wrench
Torque wrench that measures in Newton meters
INSTALLATION:
1. Remove the grips, brake levers and shifters from the handlebars, as well
as the MatchMaker clamp from the SRAM shifter.
2. Attach the MisMatch Adapter to the SRAM shifter (figs. 1, 2) using the
included 8mm bolt (part B) and a 4mm hex wrench.
3. Open up the Shimano brake lever clamp and remove the spacer (fig. 3).
Figure 3
Figure 1
Figure 2
🅑
🅐
Right-Hand Assembly
5807
9
9
5
/20
| 85-001221_INST_A
