4
Physical Details - FCS-0020/WCS-0020
Front - FCS-0020/WCS-0020
Lens
No physical adjustment is required or possible for the lens, but
you should ensure that the lens cover remain clean. The
image quality is degraded if the lens cover is dirty or
smudged.
Microphone
The built-in microphone is mounted on the front.
Power LED
(Green)
On
- Power on.
Off
- No power.
Blinking
- The
Power
LED will blink during start up. This will
take 15 to 20 seconds.
Active LED
(Green)
Off
- Camera is not capturing video.
Blinking
- Camera is capturing video
Network LED
(Green)
Off
- Wireless or LAN is not connected or camera is not
sending/receiving data.
Blinking
- Data is being transmitted or received via the LAN
or Wireless connection.
Rear - FCS-0020/WCS-0020
Antenna
Attach the supplied antenna here. The antenna is adjustable;
best results are usually obtained with the antenna positioned
vertically. (WCS-0020 only)
Power
Connect the supplied 5V power adapter here. Do not use
other power adapters; doing so may damage the camera.
Speaker
If required, an external speaker can be plugged in here.
MIC IN
If required, an external microphone can be attached here.
Attaching a microphone here will disable the built-in
microphone on the front. Microphones designed to be used
with PCs are usually compatible with this microphone input.
LAN
Use a standard LAN cable to connect your FCS-0020/WCS-
0020 to a 10/100BaseT hub or switch.
Note:
•
Plugging in the LAN cable will disable the Wireless
interface. Only 1 interface can be active at any time.
•
The LAN cable should only be connected or disconnected
when the camera is powered OFF. Attaching or detaching
the LAN cable while the camera is powered on does NOT
switch the interface between wired and wireless.
Reset
This button is recessed; you need a pin or paper clip can be
used to depress it. It can be activated at any time the camera
is in the "ready" mode.
•
WPS PBC Mode
. For the Wireless IP Camera with
Summary of Contents for CamCon WCS-0020
Page 2: ......
Page 4: ......
Page 49: ...43 Clear Button Use this button to clear the input fields ready to add a new user...