- 7 -
2) whether it is in the operative range.
8. What should I do when I can't hear very well with the Headset?
A:
Adjust the sound volume on your mobile phone, or press the S1 button of the Headset to
increase volume, or check if your mobile phone is in a good signal area.
9. Why doesn’t the Headset work suddenly?
A:
1) The headset may have run out of battery. When it is in low battery, a red LED will start to
flash.
2) Some Bluetooth mobile phones, which have a problem with the Bluetooth implementation, will
occasionally but not often, get into an Bluetooth shut-down status in unpredictable circumstances. When
this happens, please reset your mobile phone by removing the battery. ( It is not necessary to do the
Pairing again.)
Make sure that your phone has the latest version of firmware loaded onto it. Please check the
website of your mobile phone for new firmware.
10. Why doesn’t the voice dialing function work with the Headset?
A:
You may have to record your voice with the Headset to your mobile phone.
FCC Safety Statements
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired
operation.
The radiated output power is far below the FCC Radio frequency exposure limits. Nevertheless, this
device should be used in such a manner that the potential for human contact during normal operation is
minimized.
Warning:
Changes or modifications made to this equipment not expressly approved by the
manufacturer. May void the FCC authorization to operate this equipment.
Important. Please note the following:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-
Consult the dealer or an experienced radio/TV technician for help.
