Safety
Leuze electronic
MLD 300, MLD 500
9
After switch-on the laser lights up for about 10 minutes. Do not leave the installation location during this
time.
Interrupt the laser beam using a non-transparent, non-reflective object if the laser beam has inadver
-
tently been pointed at a human.
Note the current legal and local laser protection regulations according to EN 60825-1.
Laser warning signs and notice signs
There are laser warning signs near the laser beam egress pointsee figure 2.1.
Attach the supplied self-adhesive notice signs clearly visible at the safety sensor and on the device col
-
umn see figure 2.2.
If used in the U.S., attach the respective notice sign.
2.1.3 Foreseeable misuse
Any use other than that defined under the “Approved purpose” or which goes beyond that use is consid
-
ered improper use.
In principle, the safety sensor is not suitable as a protective device for use in the following cases:
• danger of objects being expelled or hot or dangerous liquids spurting from the danger zone
• applications in explosive or easily flammable atmospheres
• reachability of the location of hazard by hand from the mounting location of the safety sensor
• detection of the presence of persons in danger zones
Figure 2.1: Laser warning sign
Figure 2.2: Self-adhesive notice signs
USA
DE
GB
FR
LASERSTRAHLUNG
NICHT IN DEN STRAHL BLICKEN
LASER KLASSE 2
DIN EN 60825-1: 2008-05
Max. Leistung:
Wellenlänge: 650 nm
1 mW
LASER LIGHT
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
DIN EN 60825-1: 2008-05
Max. Output:
Wavelength:
1 mW
650 nm
RAYONNEMENT
NE PAS REGARDER DANS LE FAISCEAU
APPAREIL A LASER DE CLASSE 2
DIN EN 60825-1: 2008-05
Puissance max.:
Longueur d'onde émis:
1 mW
650 nm
LASER LIGHT
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
IEC 60825-1: 2007
Max. Output:
Wavelength:
1 mW
650 nm
Complies with 21 CFR 1040.10
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]
