Safety instructions
General safety instructions for drive components
9
Lenze ¯ BA 33.0008 ¯ 5.0
Storage conditions
¯
Up to one year:
–
Shafts and uncoated surfaces are delivered with rust protection. Aftertreatment
is required where the corrosion protection has been damaged.
¯
More than one year, up to two years:
–
Apply a long−term corrosion preventive (e.g. Anticorit BW 366 from the Fuchs
company) to the shafts and uncoated surfaces before storing the motor away.
Transport
Before transport
¯
Make sure that all components are securely mounted;
¯
Make sure that all components with a loose fastening are secured or removed;
¯
Tighten all transport aids (eye bolts or support plates).
Use lifting devices for the transport! (
¶
(
Stop!
Danger by tipping or falling loads!
Observe carrying capacities!
¯ The carrying capacity of the hoists and load handling devices must be
at least the weight of the load, weights (
¶
LEERER MERKER).
¯ Secure the load to prevent it from tipping over or falling down.
¯ Standing beneath suspended loads is prohibited!
Risk of breakage!
The motors mounted to the gearbox are partly equipped with transport
eyebolts that are
solely
intended for mounting/dismounting the motor
to/from the gearbox and that
must not
be used for transport of the
geared motor!
}
Danger!
Completely screw in transport aids (such as eye bolts or bearing plates),
they must be flat and applied over their entire surface!
If possible, the transport aids (such as eye bolts or bearing plates) must
be stressed vertically in the direction of the screw axis! Angular tension or
tension to the sides reduces the payload! Observe the information
provided in DIN 580!
Use additional appropriate lifting aids, if required, to achieve a direction
of loading which is as vertical as possible (highest payload). Secure lifting
aids against shifting!
Corrosion protection
Lenze offers paints with different resistance characteristics for drive systems. Since the
resistance may be reduced when the paint coat is damaged, defects in paint work (e.g.
through transport or assembly) must be removed professionally to reach the required
corrosion resistance.
