Lenze E82ZAFPC201, Communications Manual, Page: 27 / 118

Commissioning
Commissioning steps
6
l
27
EDS82ZAFPC201 EN 4.0
6.2 Commissioning steps
)
Note!
Do not change the setting sequence.
Step−by−step commissioning of the function module with DRIVECOM device control is
described below.
Step Description Detailed
information
1. Configure the host system (master) for communication via the function
module.
^
29
2. Inhibit the standard device via terminal 28 (CINH).
l
Set terminal 28 to LOW level.
l
Later on the standard device can be inhibited and enabled via the bus
system.
Documentation for
the standard device
3.
Connect the mains voltage and, if available, the separate voltage supply for
the function module.
l
After approx. 1 second the standard device will be ready for operation.
l Controller inhibit (CINH) is active.
^
35
Reaction
l
The green LED "Connection status to standard device" at the front of the
function module is lit (only visible with 8200 vector).
l
Keypad:
dc
(if attached)
^
85
4. Provide software compatibility with the function module.
l
DIP switch S8 = OFF
^
32
5. Activate the bus terminating resistor of the first and last bus device through
DIP switch = ON.
l
Lenze setting: OFF
^
33
6. A Set the bus device address via ...
– C1509 or
– DIP switches S1 ... S7.
If the setting via code applies (DIP switches S1 ... S7 = OFF), then the address
must be reassigned after a parameter set transfer.
^
33
B Switch off the voltage supply of the function module and the standard
device, and then switch it on again to accept the changed settings.
Address modifications via keypad become effective immediately.
7. It is now possible to communicate with the standard device, i.e. all codes can
be read and all writable codes can be adapted to the application. Documentation for
the standard device
Reaction
The yellow LED on the function module is blinking when the PROFIBUS is
active.
^
85
8. Select the function module as the source for control commands and
setpoints.
l Set C0005 = 200.
– A preconfiguration for operation with the function module is carried
out.
– Control words and status words are already linked.