RG-TDMOD 24
Drive Control & Communication
Parameter No.
1
Tmd Register #
(hexadecimal
representation)
Parameter Name
Range of Adjustment
Modbus value (decimal value)
Factory
Default
PV503
c11
120 (78H)
Configuration
Analog Output (62)
0 None
1 Output frequency 0 - 10V
2 Output frequency 2 - 10V
3 Load 0 - 10V
4 Load 2- 10V
5 Dynamic Braking
0
c17
c18
121 (79H)
122 (7AH)
Configuration Digital Outputs
(A1, A2)
0 Ready
1 Fault
2 Motor is running
3 Motor is running - CW rotation
4 Motor is running - CCW rotation
5 Output frquency = 0Hz
6 Frequency setpoint reached
7 Threshold (C17) exceeded
8 Current limit reached
c17 = 0
c18 = 1
c20
123 (7BH)
I
2
T Switch-Off
30 - 100%
100%
c25
124 (7CH)
LECOM Baud Rate
0 (9600, 8, N, 2 if C01 = 8...11)
1 (9600, 8, N, 1 if C01 = 8...11)
2 (9600, 8, E, 1 if C01 = 8...11)
3 (9600, 8, O, 1 if C01 = 8...11)
0
125 (7DH)
Not Used
126 (7EH)
RESERVED
c40
127 (7FH)
Freq. Setpoint Command
0 - 2400 (0.0 - 240 Hz)
0.0 Hz
c42
128 (80H)
Start Condition
0 Start after LOW-HIGH change at 28
1 Auto Start if 28 = HIGH
2 Flying restart (auto start disabled)
3 Auto Start if 28 = HIGH, with flying restart
1
c43
129 (81H)
Flying Restart Selection
0 Search range: C11 ... 0Hz
1 Search range: last frequency ... 0Hz
0
130 (82H)
Not Used
c48
131 (83H)
Motor Auto-Calibration
0 Calibration not done
1 Calibration enabled
2 Calibration complete
Read Only
132 (84H)
Not Used
c60
133 (85H)
Mode Select for c61
0 Monitor Only
1 Monitor and Edit
0
c61
134 (86H)
Present Fault
Status / Error Message (refer to Note 5)
Read Only
c62
135 (87H)
Last Fault
Error Message (refer to Note 5)
Read Only
c63
136 (88H)
Last but one Fault
Error Message (refer to Note 5)
Read Only
c64
137 (89H)
Last but two Fault
Error Message (refer to Note 5)
Read Only
1 = The drive's programming code number; (2) = Two decimal places assumed.