Information LI101F
Page 5
Commissioning the LI101F
When you have finished connecting your LI101F, you may switch your
Digital plus by Lenz
®
system and the computer back on.
The luminous diode (LED) of the
LI101F will shine if the connection
created between the interface and the
XpressNet is correct. This red LED is
located in the XpressNet socket. When
on the transparent phone plug will
shine. During operation the LED will
remain on.
The luminous diode (LED)
The LED of the LI101F signals operational readiness. Constant shining of
the LED indicates that the device is in operation and communicating with
the command station. Constant flashing, however, indicates that the
LI101F is unable to communicate with the command station. Possible
explanations are:
•
The command station is in programming mode (a decoder is being
read out or programmed on the programming track).
•
The A or B line of the XpressNet are either not connected or
wrongly connected.
•
The LI101F is the sixth device being used by the Compact (or Atlas
Commander) or the SET02/03 (these devices address a maximum
of 5 XpressNet devices).
•
The LI101 has an XpressNet address not supported by the system.
(SET02/03 only support XpressNet addresses 1,2,3,29 and 30).
•
The command station does not address the XpressNet devices
(damaged command station).
