Lenovo ThinkPad S5 2nd Generation, Hardware Maintenance Manual, Page: 45 / 110

Error codes Solutions
0001: Reset error (platform reset not de-asserted)
1. Remove all power resources (the ac power
adapter, removable battery, and coin-cell battery).
If your computer has a built-in battery, reset the
computer by inserting a straightened paper clip
into the emergency-reset hole. Wait for one
minute. Then reconnect all power resources.
2. Replace the system board (service provider only).
0002: Internal bus error
Replace the system board (service provider only).
0281: General embedded controller error
Replace the system board (service provider only).
0282: Memory module error
1. Reinstall or replace the memory module.
2. Replace the system board (service provider only).
0283: PCI resource error
1. Remove PCIe devices (the M.2 card, PCIe card,
and so on) (service provider only).
2. Replace the system board (service provider only).
0284: TCG-compliant functionality-related error (might be
the BIOS code validation failure)
Replace the system board (service provider only).
0285: TCG-compliant functionality-related error (might be
the TPM initialization failure)
Replace the system board (service provider only).
0286: Integrated graphics error
Replace the system board (service provider only).
0287: Discrete graphics error
1. Reinstall or replace the discrete graphics card
(service provider only).
2. Replace the system board (service provider only).
0288: Computer display error
1. Reconnect the display cable on both the system
board side and the computer display side (service
provider only).
2. Replace the system board (service provider only).
No-beep symptoms
Table 4. No-beep symptoms
Symptom or error FRU or action, in sequence
No beep, power-on indicator on, LCD blank, and no
POST.
1. Ensure that every connector is connected tightly
and correctly
.
2. Reseat memory module.
3. Replace the system board.
No beep, power-on indicator on, and LCD blank during
POST.
1. Reseat memory module. .
2. Replace the system board.
The power-on password prompt appears. A power-on password or a supervisor password is set.
Type the password and press
Enter .
The hard-disk password prompt appears. A hard-disk password is set. Type the password and
press
Enter .
Chapter 4
.
Related service information
39