Lenovo ThinkCentre Edge 92, Hardware Maintenance Manual

Page: 153 / 176

This section provides instructions on how to replace the system fan.
To replace the system fan, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See “Removing the computer cover” on page 121.
3. Remove the front bezel. See “Removing and reinstalling the front bezel” on page 122.
4. Pivot the drive bay assembly upward to access the system fan. See “Accessing the system board
components and drives” on page 124.
5. Remove the hard disk drive for easier access to the system fan. See “Replacing the hard disk drive” on
page 130.
6. Remove the heat sink fan duct. See “Locating parts on the system board” on page 81.
7. Note the cable routing and disconnect the system fan cable from the power fan connector on the
system board. See “Locating parts on the system board” on page 81.
8. The system fan is attached to the chassis by four rubber mounts. Remove the system fan by cutting the
four rubber mounts
1
and lifting the system fan out of the chassis.
Note: The new system fan will have four new rubber mounts attached.
3
4
5
6
7
8
Figure 89. Removing the system fan
Chapter 10
.
Replacing FRUs (machine types: 3377, 3386, and 3388)
149