6
To use the Plug and Play feature in Windows 95 or Windows 98, files
should be loaded from the IBM Monitor Installation diskette.
1. Turn off the computer and all attached devices.
2. Ensure that the monitor is connected correctly.
3. Turn on the monitor and then the system unit. Allow the system to boot
into Microsoft Windows95 or Microsoft Windows98.
Your computer’s Plug and Play code may warn you that your system
hardware has changed. This probably means that it has detected your
new monitor for the first time.
4. Open the D
ISPLAY
P
ROPERTIES
window by clicking on S
TART
, S
ETTINGS
,
C
ONTROL
P
ANEL
and then double clicking on the D
ISPLAY
icon.
5. Select the S
ETTINGS
tab.
• In case of Windows 95 :
6 -
1.
Select the C
HANGE
D
ISPLAY
T
YPE
button.
2
. Select the C
HANGE
M
ONITOR
T
YPE
button.
• In case of Windows 98 :
6 -
1
. Select the A
DVANCED
button.
2
. Select the M
ONITOR
tab.
3.
Open the U
PGRADE
D
EVICE
D
RIVER
W
IZARD
window by clicking on
C
HANGE
button and then select the N
EXT
button.
If the U
PGRADE
D
EVICE
D
RIVER
W
IZARD
is open go to step 6-
3.
if not
contine to step
4
.
4.
Select the “Display a list of the known drivers for this device so that
I can choose a specific driver” and then select the N
EXT
button.
7. Insert the Setup diskette into drive A: and select the H
AVE
D
ISK
button.
8. Select OK.
9. Choose IBM T545H monitor and select OK. The files will be copied from
the diskette to your hard drive.
10.Close all open windows and remove the diskette.
11.Reboot the system.
The system will automatically select the maximum refresh rate and
corresponding Color Matching Profiles.
Configuring your Monitor
Setup Diskette for Microsoft®Windows®95 or Microsoft®Windows®98
This section must be
completed before
continuing with the
Microsoft Windows95 or
Microsoft Windows98 Auto
Setup on page 8.
i
On LCD monitors, unlike
CRTs, a faster refresh rate
does not improve display
quality. IBM recommends
using either 1024 x 768 at a
refresh rate of 60Hz or 640 x
480 at a refresh rate of 60Hz.
