Lenovo S510, Hardware Maintenance Manual

Page: 96 / 142

6. Remove the screw that secures the front audio and USB assembly. Then, pivot the front audio and USB
assembly as shown to remove it from the chassis.
Figure 21. Removing the front audio and USB assembly
7. Align the tab 1 on the right side of the new front audio and USB assembly with the right side of the
corresponding slot in the chassis. Then pivot the front audio and USB assembly inwards until it snaps
into position on the left side.
Figure 22. Installing the front audio and USB assembly
8. Install the screw to secure the front audio and USB assembly to the chassis.
9. Reconnect the front audio and USB assembly cables to the front audio connector and the front USB
connector on the system board. See “Parts on the system board” on page 34.
10. Install the front bezel. See “Replacing the front bezel” on page 82.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 113.
Replacing the card reader
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 “Read this first: Important safety information” on page 1.
To replace the computer handle, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Remove the computer cover. See “Removing the computer cover” on page 82.
90
Lenovo S510 Hardware Maintenance Manual