Lenovo RT11.0VA, Installation And User Manual

Page: 58 / 102

Depending on overload conditions, the UPS remains in Bypass mode for at least 5
seconds and will stay in this mode if three transfers to Bypass occur within 20
minutes.
The UPS transfers to Bypass mode when:
v
the user activates Bypass mode through the front panel
v the UPS detects an internal failure
v
the UPS has an overtemperature condition
v the UPS has an overload condition listed in the Specifications section
Note:
The UPS stops operating after a specified delay for overload conditions
listed in the Specifications section. However, the UPS remains on to alarm the fault.
Standby mode
When the UPS is turned off and remains connected to the AC source, the UPS is in
Standby mode (
indicator). Depending if Bypass Standby setting is enabled, the
output is powered but not protected. The battery packs recharge when necessary
and the communication ports are powered.
Operating modes: summary
The following table summarizes the characteristics of your UPS unit in each
operating mode.
Table 3. Operating modes
Mode Online Battery Bypass Standby
Load powered powered powered no power
Batteries charging discharging charging charging
Protection features:
Power failure yes n/a no no
Power sag yes n/a no no
Power surge yes n/a no no
Under voltage yes n/a no no
Over voltage yes n/a no no
Line noise yes n/a no no
Frequency variation yes n/a no no
Switching transients yes n/a no no
Harmonic distortion yes n/a no no
Other features:
Frequency conversion yes n/a no no
AC source normal n/a bypass normal
Note: In High Efficiency mode, the UPS is in Bypass mode and transfers to Battery
mode in less than 10 microseconds (ms) when utility power fails. Transfers to High
Efficiency (HE) mode will be active after 5 minutes of Bypass voltage monitoring:
if Bypass quality is not in tolerance, then the UPS will remain in Online mode.
40
Installation and User's Guide