Lenovo RackSwitch G8052, Installation Manual

Page: 21 / 86

© Copyright 2015 Lenovo Chapter 2: Switch Components
21
RJ-45 Management Port
The RJ-45 management port on the front panel supports 10/100/1000BASE-T,
in-line switch management.
To attach an RJ-45 connector to the switch, push the RJ-45 cable connector into the
port connector until it clicks into place.
To disconnect the RJ-45 cable, squeeze the release tab and gently pull the cable
connector out of the switch connector.
RJ-45 Management LEDs
The RJ-45 management port LEDs are oriented as shown in the following figure.
Figure 5. RJ-45 management port LEDs
Status LEDs for the RJ-45 management port are described in the following table.
Reset Button
The Reset button is recessed within a hole on the front panel. Use a straightened
paper clip or similar object to press the Reset button. The Reset button allows
technicians to reset the switch as follows:
•
Normal reset—Press and release Reset. The switch resets and reloads the
configuration files.
• Factory reset—Press and hold Reset for more than five seconds. The switch
resets and reverts all configuration settings to the factory defaults.
Table 3. RJ-45 status LEDs behavior
LED State Functional Meaning
Link Steady green Link up
Flashing green Activity
Off No link
Speed Steady green 100/1000 Megabits per second (Mbps)
Off 10 Mbps or no link
Link LED Speed LED