Lenovo 7Y45, Setup Manual

Page: 81 / 116

2. Touch the static-protective package that contains the new optical drive to any unpainted surface on the
outside of the server; then, , take the new optical drive out of the package and place it on a static-
protective surface.
To install an optical drive, complete the following steps:
Step 1. Remove the front door (see “Remove the front door” on page 57).
Step 2. Remove the front bezel (see “Remove the front bezel” on page 58).
Step 3. If necessary, press the tabs on the side of the plastic bay filler of the optical drive bay and push the
plastic bay filler as shown to remove it.
Figure 55. Plastic bay filler removal in the optical drive bay
Step 4. If necessary, insert two of your fingers into the holes in the EMI shield and carefully pull the EMI
shield out of the chassis.
Chapter 3
.
Server hardware setup
77