Lenovo 7D8J, Setup Manual

Page: 67 / 122

Table 28. Drive activity LED behavior
Status Color Description
Solid on White The drives are active.
Off None The drives are not active.
2. Use the Lenovo XClarity Provisioning Manager Lite to configure the RAID if necessary. For more
information, see
https://sysmgt.lenovofiles.com/help/topic/LXPML/RAID_setup.html
.
Install the drive cage (bay 1-2)
Follow this procedure to install the bay 1 drive cage and bay 2 drive cage.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
About this task
Attention:
• Read “Safety inspection checklist” on page 43 and “Installation Guidelines” on page 41 to ensure that you
work safely.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
AU3iY3F7lq3qfqr5caGbIu
.
Procedure
Note:
Install the bay 1 drive cage first; then, proceed to install the bay 2 drive cage.
Step 1. Install the bay 1 drive cage.
a. Align the bay 1 drive cage to the slots on chassis; then, install it into the chassis. Make sure
the drive cage is seated correctly in the chassis.
b. From the inside of the chassis, fasten the screw that secures the bay 1 drive cage to the
chassis.
c. From the outside of the chassis, fasten the screw that secures the bay 1 drive cage to the
chassis.
Chapter 3
.
Server hardware setup
63