7.
To install the new hard disk drive into the bracket, flex the bracket and align
pin
1
, pin
2
, pin
3
, and pin
4
on the bracket with the corresponding
holes in the hard disk drive. Do not touch the circuit board
5
on the bottom
of the hard disk drive.
8.
Connect the signal cable and the power cable to the rear of the new hard disk
drive.
9.
Slide the new hard disk drive into the hard disk drive bay and pivot it down
until it snaps into position.
10.
Reconnect the power cable to the optical drive.
What to do next:
v
To work with another piece of hardware, go to the appropriate section.
v
To complete the installation or replacement, go to “Completing the parts
replacement” on page 31.
Replacing the optical drive
Attention
Do not open your computer or attempt any repair before reading and
understanding the “Important safety information” in the
ThinkCentre Safety
and Warranty Guide
that came with your computer. To obtain a copy of the
ThinkCentre Safety and Warranty Guide
, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the optical drive.
To replace the optical drive, do the following:
Figure 10. Installing the hard disk drive into the bracket
Chapter 2. Installing or replacing hardware
19
Summary of Contents for 3692A3U
