Lenord+Bauer MiniCODER GEL 2444, Operating Instructions Manual

Page: 56 / 68

5 Mounting and connection Bauer Connecting MiniCODER electrically
56 GEL 2444
E
nglis
h
5.3.3 Checking function
The MiniCODER GEL 2444K
␣
P
␣␣␣␣␣␣␣
can be adjusted, analysed and
configured using the testing and programming unit GEL 211.

Check the function of the MiniCODER using a suitable instrument, preferably an
oscilloscope.

Connect the MiniCODER to the instrument (
→
page 64 ff).

Connect the MiniCODER to the power supply (
→
page 64 ff).

Switch on the power supply.

Slowly rotate the target wheel and monitor the output signal on the instrument.
If function is correct an adequate sine wave or square-wave signal will be displayed
on the oscilloscope (
→
page 42 ).

Switch off the power supply.

Remove the instrument and the power supply.
5.3.4 Completing mounting
►
After a successful function test, tighten the two mounting screws to the torque of
max. 2.5 Nm.
M
5.4 Connecting MiniCODER electrically
Pay attention to the minimum bending radius so that the connection
cable is not damaged by excessive bending (
→
page 59 f).

Observe the instructions on electromagnetic compatibility while laying the cables
(
→
page 48 f).

Correctly connect the MiniCODER as per the pin layout (
→
page 64 ff).