21
Network Address and Commissioning
After the system has been installed, each indoor
unit must be assigned an address as part of the
commissioning procedure.
Spot Check Instructions
No.
Content
Recorded Value/Date
0
Normal display
1
Communication address of indoor unit
2
Indoor unit capacity (horsepower)
3
Network address of indoor unit
4
The actual setpoint temperature
5
The actual indoor temperature T1
6
The middle coil temperature T2
7
The coil inlet temperature T2A
8
The coil outlet temperature T2B
9
The actual superheat temperature
10
The actual subcool temperature
11
Error Code
12
Indoor software version
13
End (--)
Use the Spot Check Performance tables below and the
Manual button on the unit receiver to view diagnostic
information the indoor unit.
Table 4. Spot Check Performance Identification Table
This Spot Check Performance table is located on the unit service panel.
The diagnostic information can also be obtained using the wired remote controller.
Summary of Contents for VRF VMDB Series
Page 23: ...23...
