Operation
49
nation required.
Raise the plough completely.
Turn the plough completely.
Turn the plough back after 3–6 seconds.
Lower the plough.
Check whether the setting is correct.
If not, repeat the adjustment process de-
scribed above.
11.6 Working
depth
The working depth is set using the tractor hydraulics and, if fitted, the plough‘s
depth wheel. For instructions on setting the tractor hydraulics, please refer to the
operating instructions provided by the tractor manufacturer. The tractor hydraulics
should be set to draft control or mixed control.
The depth wheel on the plough should only act as a depth control wheel and
should prevent the plough from working too deep. Therefore the weight of the
plough should be transferred to the tractor as far as possible to avoid excess
wheel slip. Excess wheel slip causes premature tyre wear and increases fuel con-
sumption.
11.7 DURAL
plough
body
11.7.1 Contact angle
The clearance between the share tips and
the plough frame should be the same for
all plough bodies. The dimension D should
be approx. 1.5 cm. The necessary adjust-
ment is made with the adjusting screw (1).
Loosen the body screw (2) and the
clamping screw (3).
A
1
2
D
1
