LEMAN TOU030, Manual

Page: 80 / 92

WIRING DIAGRAM
The electric motor is designed for the S6 40%
operating mode. And the motor is equipped with a
thermal protect system, therefore the motor is
automatically switched off in the event of an overload.
The motor can be switched on again after a cooling
down period that can vary. Electrical connection
cables often suffer insulation damage. Such defective
electrcal connection cable must not be used as the
insulation damaged makes them extremely
hazardous.
Check electrical connection cables regularlly for damage.
Make sure the cable is disconnected from the mains when
checking.
Electrical connection cables must comply with the
regulations applicable in your country.
MAINTENANCE
Always siwtch off the motor and disconeect the plug
from the power supply prior to any maintenance and
cleaning work.
Before operation:
1. Visual check distance which is 3-8mm,between the
milling tool and fence extrusion, between milling tool
and table.
2. Visual check of power cable and power cable plug for
damage; if necessary have damage parts replaced by a
qualified electrician.
General maintenance:
Check for the following conditions and repair or replace
when necessary.
1. Loose mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Damaged V-belt.
5. Any other condition that could hamper the safe
operation of this machine.
Table
Tables can be kept rust-free with regular applications of
light grease.
Lubrication
The only parts on this machine that require periodic
lubrication are the ways where the cartridge slide rides on
the machine housing and where the worm gear and
bushing are located. Use a light grease or anti-seizing
compound on the ways and worm gear, and give the shaft
mount a shot of light oil.
V-Belt
Avoid getting grease or oil on the V-belt or pulleys. Check
the V-belt, as part of a monthly inspection for proper
tension and belt condition.
Cracking and glazing could result in belt failure. Replace
the belt if such conditions appear.
Schedule
Regularly blow out air vents with compressed air and
keep the exhaust port clear. Always wear a dust mask
during this operation.
For every 1 hour of use, clean and wipe down with light
grease:
Table and miter gauge slide
Fence faces
For every 5 hours of use, clean and oil:
Spindle column and cartridge
Offset adjustment mechanisms on fence
All worm drive and other gears
Once a year, replace the V-belt.
11
EN