LEMAN TOU030, Manual

Page: 75 / 92

Adjust the scale mount
1. Release the 2x allen bolts M6x16 and shift the scale mount
to the left or to right make sure the pointer with the “0”
scale
，
then tighten the 2x allen bolts
2. Slide the guide rail (3) over the intermediate plates (2) and
tighten the thumbscrews .
3. Insert the folding s
top (4) into the end stop and tighten
the T-screw.
Installing the feeder ass'y
1. Insert the feeder arm into feeder base and secure it with
startype screw M8x25.
2. Place the Feeder Ass'y and Anti-kickback Ass'y onto the
Feeder Arm and secure it.
Mounting bracket
Fit the two mounting brackets with two "I" shape insert block to
machine housing.
4 allen bolts M8x45
Installing the Sliding Carriage (optional)
Installing the sliding bench
1. Fit the scale mount (1) to the sliding bench.
2 allen bolts M6x16
2. Insert the intermediate plates (2) into the stop tube do not
tighten the screws.
2 washers 6mm
2 thumbscrew M6
3. Fit the stop tube on the sliding bench.
1 swing bolt
2 washers 8mm
1 Wave washer 8mm
Mounting the sliding rail
1 hex nut M8
Insert the Sliding rail from above at a slight angle into the
The wave washer must be between the stop tube and the
mounting brackets and tighten the wing nuts.
sliding bench.
Figure 9
6
Figure 7
Figure 8
EN