ProVision 3 Installation Manual
8100-35521-00
Rev. A1
Leidos Security Detection & Automation, Inc.
–
Proprietary
Page 65 of 119
© 2020 Leidos. All rights reserved
2.
If the OCP is being located on the left column at the electrical enclosure end, and the power input box
is being located in the upper position at the motor/pulley end of the scanner, you must separate the
cables.
3.
Route the power input box/cable to its selected location and route the OCP, Ethernet and any other
cables to the OCP’s s
elected location.
Figure 69: Cabling Route with Power Input Box, OCP, and Other Cables Together
4.
Cable-tie all cables. No cables should be allowed to drape off the side of the scanner, or drape into
the scanner. In addition, the cables should be tied in such a way as to prevent them from becoming
tangled with the moving parts on top of the scanner.
11.23
Top Down Power
Install an optional top down power per 8100-23121-TM option section or 8600-28515-IP.
11.24
Power Input Box
1.
Install the power input box at the selected location, either at lower right of the electrical enclosure end
or at upper left of
the motor/pulley end.
The power input box is fastened to the outer window bracket support, as shown in the following
figure, with two M6 x 12mm FHC bolt (0201-10069-12) one in each bracket.
