Leica MOJO RTK, User Manual

Page: 31 / 212

System Installation
mojoRTK
31
)
Be careful removing the backing tape from the sticking blocks. Make sure
that you only peel off the tape and do not rip the adhesive from the
backing tape.
Keep in mind that both GPS antennas should mount with the whip
antennas in the forward position.
4. Select the radio/DIN slot that the mojoRTK console will be installed into and
remove either the radio that is there or the blanking plate in the selected slot.
5. Run the antenna cables to the rear of the selected radio/DIN slot for connection
to the mojoRTK console, making sure that there is enough slack in the cables to
reach outside the selected radio/DIN slot.
)
Route the cables through existing grommets if possible; if not, modification
may be required to route the cables to the desired location. If creating a
new entry point, make sure to use a grommet to protect the cables.
)
The cables must not be cut, kinked, or bent tightly or their performance will
be degraded and may even result in system failure.