Leica GR10, Operational Manual

Page: 113 / 317

Printed Documentation
Outgoing data stream wizard: Connection
Background Information
Data can be streamed from the GR10 using a variety of communication types.
Setting Descriptions
The table below describes the settings that can be configured on the Connection page.
Setting Description
Connection type
Select the connection type.
TCP/IP server The receiver works as a TCP server allowing TCP
clients to connect to the receiver's ports to receive
the data streams.
TCP/IP client This setting allows the receiver to act as a TCP client
and send data out to a configured IP address and
port. This way no port has to be opened in the
firewall to allow clients to connect to the receiver.
Furthermore since the data stream is now sent to a
PC port, the number of connections to the data
stream is not limited by the receiver.
NTRIP server (source) This mode allows the receiver to act as Ntrip Server,
and to provide data to an Ntrip Caster.
In terms of TCP/IP, the Ntrip server mode is in fact a
TCP client mode. As an Ntrip Server, the receiver
connects to a caster and starts to stream data.
Serial port The receiver streams data out of the physical serial
port (P1).
Radio The receiver streams data using an attached radio.
GSM / Modem / CDMA -
dial up
The receiver streams data using an attached GSM,
Modem or CDMA dial up service.
Press to go back to the previous wizard step. Press to continue to the next wizard step.
Press to cancel and return to GNSS management: Outgoing data stream .
112