Printed Documentation
Outgoing data stream wizard: Configure Serial port
Background Information
This mode allows data to streamed out of the physical serial port (P1).
This page allows you to change the settings of the instrument's serial port.
Do not select the connection type Serial Port if you have a radio/modem/phone connected
to the serial port (P1). In this case you must select the connection type Radio or
GSM/Modem/CDMA - dialup. The serial port settings for these devices are configured in
Receiver settings: Device Management
Setting Descriptions
The table below describes the settings that can be configured on the Configure serial port page.
Setting
Description
Baud rate, Parity,
Data bits, St p bits
o
Select the port settings for the communication between the receiver and the serial
port.
Flow control
Defines which kind of handshake is used.
•
None: No handshake.
•
RTS/CTS: Handshake in both directions.
Press
to go back to the previous wizard step. Press
to continue to the next wizard step.
Press
to cancel and return to
GNSS management: Outgoing data stream
.
116
Summary of Contents for GR10
