Button GNSS inactive
Tap on the button GNSS to set up the GNSS antenna. Currently
GS18 T and GG04 plus are supported.
•
Refer to "Connect the GS18 T antenna" to set up the GS18 T
antenna.
•
Refer to "Connect the GG04 plus antenna" to set up the
GG04 plus antenna.
☞
The GNSS antenna connection can only be done at the
home screen, not during acquisition.
Button GNSS active
GNSS button indicates the connection status to the GNSS antenna.
•
Make sure that the button stays green throughout the entire
acquisition once a GNSS antenna is used.
Button TPS inactive
TPS is not supported yet.
4.3
Data Acquisition
From the project summary, tap
Go to Acquisition
to get to the acquisition
screen. Refer to "6 Procedures for Working with the DSX" for details.
There are two ways to get to the project summary:
•
Open a draft:
Open a draft by selecting from the right column of Home screen or
searching from drive with
Load Project
button. Tap
Go to Acquisition
at
the bottom right.
•
Set up a project from scratch:
Tap the
Grid Scan
button in the center column of Home screen --> go
through project setup wizard until the project summary screen. Tap
Go to
Acquisition
at the bottom right.
Go to Acquisition
DXplore Software
27
