LEHR LP5.0 HP Rev.A 2014
39
1. Remove the spark plug hi tension lead. There are three bolts on the brack-
et assembly. Remove bolts and nuts from position
1
and
2
, and loosen
bolt
3
. Rotate the bottle bracket to expose the starter assembly bolt.
2. Remove the three bolts
B
that secure the starter assembly. Loosen the
lock nut that holds the start in gear protection cable. Remove the cable,
then remove the starter assembly.
3. If adjusting the coil to fly wheel gap, loosen the two coils bolts
D
and set
the gap to
0.4 - 0.6mm (0.016-0.024 in)
. Torque bolts to
10 Nm (7 ft-lbs)
.
Recheck the gap on both coil legs to be sure it didn’t change while
torquing the bolts.
4. If replacing, disconnect the primary wire and the ground wire and the two
attaching bolts
D
and remove the coil.
5. Install the new coil and adjust the flywheel to coil leg air gap
C
to:
0.4 ~ 0.6 mm (0.016” ~ 0.024”)
6. Torque the bolts
D
to 10 Nm (7.2 ft•lbs)
7. Reassemble starter assembly, bottle bracket and spark plug hi
tension lead.
Adjusting or Replacing Ignition Coil
3
1
2
3
B
B
C
B
D
3
Summary of Contents for LP 5.0S
