10
PUB 751-0012
Rev. C—1/12/2012
7.
See Fig. 8
. Center tour box base creating equal
distances of 1 3/8” from edges of tour box base
and luggage rack side plates.
8. When base is centered, tighten mounting hard-
ware.
9.
See Fig. 9
. Install tour box base cover included
with tour box by snapping into place. Remove
rubber pin cover from tour box base.
10. Install tour box on base by latching front section
first and pressing rear of tour box into place.
11. Route tour box wiring harness along inside of
right hand luggage rack side plate and toward
battery. Do not secure harness at this point.
NOTE: Wiring instructions reference a 2009
model unit. For 2008 and older models, be
sure to reference your OEM service manual
for specific wiring diagrams and use tour
box wiring diagram included with your tour
box.
12.
See Fig. 10
. Locate trike body wiring harness
on right side of battery (looking from rear) and
carefully remove heat shrink to expose wiring.
13.
See Fig. 10-A
. With heat shrink removed, lo-
cate brake light wire (white wire with black
stripe).
TOUR BOX INSTALLATION CONTINUED
Fig. 8
Fig. 9
Luggage rack side plates
Edge of tour box base
Fig. 10
Tour box base cover
Remove heat shrink from wiring harness
Locate brake light wire
Fig. 10-A
Remove pin cover
