Installation Guide
Page 9 of 12
Harley-Davidson: Sportster
lock nut. Place a 1/2" jam nut on bolt and thread bolt onto T-
bracket until the distance between top of bracket and
bottom of bumper is 1-1/4". Secure jam nut to bracket as
shown below.
b. Install top body support to H-D frame using the hardware
indicated below on both sides. See Figure 16.
Figure 16
c. Install the square support body mount onto the back of the
OE bike frame. Place four 5/16 washers between the
support body mount and OE bike frame. See Figure 17
which is viewing the part from bottom of trike.
Figure 17
d. To install the LH body mount bracket,
use the two short (15/16
”) spacers with
the bracket and place it at footpeg
mounting holes. Use 3/8-16x2
” HHCS
with lock washer and washer. Torque to
44 ft-lbs. See the following figure below.
e. For the RH body mount bracket, use
both long (1-
1/8”) spacers with the
bracket and place it at footpeg mounting
holes. Use 3/8-16x2-
1/4” HHCS with
lock washer and washer. Torque to 44
ft-lbs.
f. To install the body remove both shocks.
Place both onto both mounting brackets
and rubber bumper.
g. Reinstall the shocks. Reference shock
installation.
h. Slide body around the bike frame. Install
the seat center post as shown below.
Do not torque yet.
i. Verify the body has a minimum gap of
1/4" between the body and cover which
is indicated in Figure 18.
