21
Differential Installation
NOTE: The OEM transmission output shaft boot
is not reused.
1. Shift transmission into NEUTRAL.
2.
See Fig. 1.
Install U-joint to driveshaft yoke.
Grease fitting should face yoke.
•
(1) Driveshaft Yoke– LY1002
•
(1) U-Joint– S002086
3.
See Fig. 2.
Apply Loctite retaining compound
(Green) to yoke splines and Install the stub
shaft into yoke. End of shaft should be flush
with yoke surface. Install set screw and torque
to
19 ft-lbs.
•
(1) Stub Shaft– LS6305
•
(1) Set Screw– CS3978
4.
See Fig. 3
. Install collar and spring to OEM
driveshaft as shown.
•
(1) Driveshaft Collar– S002091
•
(1) Driveshaft Spring– S002201
5. Grease all internal splines on Honda motorcy-
cle yoke.
NOTE: Ensure that centers of universal
joints are aligned in phase as closely as
possible (centers may not line up exactly).
6.
See Fig. 4.
Assemble drive shaft as shown.
7. Install drive shaft through swingarm tunnel and
onto output shaft of transmission. Ensure drive-
shaft is fully engaged on transmission output
shaft.
DIFFERENTIAL INSTALLATION
Fig. 1
Fig. 2
Shaft flush
with yoke
Secure with
set screw
Collar
Spring
Fig. 3
Fig. 4
Align U-joints
