Configuring the Omizzy™ server
Click on “Installation”, “Alarm”.
Click on the “Intruder alarm control panel” item
to change its parameters.
Select “Radio control panel”.
Select “Radio control panel”.
Fill in the Zone and Channel fields.
Click on the eye in the “Control”, “Alarm” screen
to activate the alarm, then click on the eye again
to deactivate the alarm.
The Radio interface will then be taken into account
by the Omizzy™ server.
- Displaying the status of
alarms:
Whatever type of intruder alarm control panel is
selected, it is possible to associate a camera with it,
to store the image of the house at the time
of detection.
It is also possible to associate one or more e-mail
addresses, so that a warning message can be sent
at the time of detection.
Caution
:
The SCS connection must never be disconnected from
the Omizzy™ server.
If it does become disconnected, the Radio interface
registration procedure must be repeated by the server.
It is possible to display the status of the intruder alarm
control panel from the “Control”, “Alarm” page and
to control its activation/desactivation by clicking on
the eye.
It is also possible to ascertain the status of the various
sensors by clicking on “Intruder alarm control panel”.
Operating mode icons:
: Indicates that the alarm is on ;
: Indicates that the alarm is inactive ;
Status icons:
: Indicates that no alarm has been detected ;
: Indicates that a sensor has detected an alarm
event.
24
Configuration (continued)
