- Procedure No. 1 :
This procedure does not require the use of a PC.
After wiring and configuring the installation (control
panel, peripherals and Omizzy™ connected to one
another), take the control panel out of the flush-mounting
wall box.
Power the installation and check that the control
panel is in maintenance state (alternate flashing
of the red LEDs).
Caution :
This operation deletes all the remote controls which have
previously been registered. Remember to re-register them
before quitting “PROG” mode.
Press pushbutton “P”
on
the control panel. The yellow
indicator lamp
lights and
there is an audible beep.
A second short audible
signal indicates that
communication has been
successfully established
between the control panel
and Omizzy™.
I / O
~
Sel
P
AUX
Sel
P
OFF
ON
OFF
ON
Set the selector switch
on the control panel
to “ON”.
The “AUX”
and
indicator lamps on
the control panel flash.
DES
ACT
IVAT
ION
ALA
RME
SEL
ECT
PRO
G
AUX
ILIA
IRE
AUX
I / O
AUT
O-P
ROT
ECT
TEN
SIO
N
~
TES
T
Sel
P
PRO
G
TION
AUX
ILIA
IRE
AUX
AUT
O-P
ROT
ECT
OFF
ON
OFF
ON
Set the selector switch
on the control panel
to “OFF”.
A long audible signal (approximately 4 seconds)
indicates that the programming has been
unsuccessful (repeat the operation).
The control panel can now be
activated/desactivated from the server.
When the last remote
control unit has been
programmed, press the
“Sel” pushbutton.
I / O
~
Sel
P
AUX
Sel
P
I / O
~
Sel
P
AUX
Attach the 2 lenses and
press the pushbutton.
A beep sounds.
21
