LEGRAND MIDDLE ATLANTIC FlexView 800 Series, Instruction Sheet

Page: 14 / 18

Page 14
ATTACHING YOUR DISPLAY ONTO THE HORIZONTAL MOUNTING BRACKET (CONTINUED)
Bottom
Hinge
(on either door)
Top Hinge
(on either door)
FIGURE P
NOTE : The door on your cart comes
pre-assembled the hinges inserted into
holes on the left side, and the catch is
located on the right. This topic may be
used to reverse the door, if desired.
1. Twist and lift bottom and top hinges
(in that order) on one of the two
doors and lift it off your cart.
( FIGURE P )
2. Carefully rotate the same door and install
the top and bottom hinges (in that order)
into the holes on the other side of your
cart.
3. Repeat the process for the other door.
4. Use power driver and #2 Philips bit to
remove (2x) screws and the catch (for
the lower door only) from the left side of
the cart and install it to the corresponding
location on the right side.
REVERSING THE DOOR
11. Hand tighten the display leveling screw you did not use for your leveling adjustment, and then
use the slotted screwdriver or 5/16” socket and wrench to tighten the three display bracket screws.
NOTE : Top rear
of cart shown.
FIGURE N
Display
Bracket
Screws
Display
Leveling
Screws
9. With at least one other person bracing the bottom end of the cart, carefully lift the top end and gently
place it upright onto the leveling feet.
10. Have someone slightly tip the cart while another person carefully makes any necessary final leveling
feet adjustments.