3
HD4657M3
HD4657M4
HC4657M3
HC4657M4
HS4657M3
HS4657M4
573912
573913
Touch control
MQ00110-f-EN
07/06/2014
3. Scenario module control
3.1 Addressing
Function
Virtual configuration (MYHOME_Suite)
Physical configuration
Room (of the scenario module)
0-10
A=1-9
Lighting point (of the scenario module)
0-15
PL=0-9
2. Device locking/unlocking
To configure use MYHOME_Suite virtual configuration
NOTE:
Use only the screwdriver supplied to operate the P button for programming and LED
brightness adjustment.
1.3 Programming the buttons
To associate each button with a different command, the procedure is as follows:
1) Briefly press the button on the back, the LEDs will light up in rotation;
2) Within 20 seconds, touch the button you want to program: the LED will start
flashing, indicating activation of the programming mode;
3) Set the command you want to assign to the button, using the controls and/or the
corresponding actuator, the LEDs will start to rotate;
4) You can now repeat steps 2 and 3 for all the buttons, including any button that you
have already assigned in case you want to change it;
5) Briefly press the programming button or wait 20 seconds to exit programming.
Deleting button programming
1) Briefly press the button on the back, the LEDs will light up in rotation;
2) Within 20 seconds, press the button you want to delete and hold it for 4 seconds;
from this moment onwards the deleted button will no longer activate any command
until it is reprogrammed;
3) The corresponding LED will blink for 4 seconds alternately with the others, after
which you can repeat step 2 to delete other programming;
4) Briefly press the button or wait 20 seconds to exit deletion.
NOTE:
To delete the programming for all the buttons simultaneously, briefly press the
button on the back, the LEDs will light up in rotation; press again and hold down the
button on the back for 10 seconds: the LEDs will blink for approximately 4 seconds, thus
confirming deletion of all the programming.
This operating mode is only used if the system has a scenario module F420, the
combination is made by assigning the same address to both items. The user can create,
delete or modify the scenarios contained in the scenario module and is able to call them
up using the buttons. The procedure allows you to save up to 16 scenarios using two
devices with 8 buttons, or three devices with 6 buttons.
To configure the "Installation level" and the "Destination level" and for Button activation
delays use MYHOME_Suite virtual configuration
