HP-4 Wet Location Surface Mount Installation Instructions
7 of 9
© 2019 FINELITE, INC. ALL RIGHTS RESERVED. Form - 98439. V2 EFFECTIVE DA
TE: 09/09/19
Joiner/Ender
Starter
A. Mount Joiner/Ender to Structure
Option 1 (Shown) - Mount to Threaded Rod
•
CRITICAL: If luminaire contains a sensor, refer to Sensor Addendum
before joining luminaires.
•
Align mounting holes with hanging hardware.
•
Install 1/4"-20 nut and 1/4"-20 washer onto 1/4"-20 threaded rod.
•
NOTE: If installing a joiner luminaire, leave nut loose, allowing
luminaire to hang at an angle.
•
If there is no joiner/ender, then tighten nuts fully.
Step 5 - Joining Luminaires
Aligner Sleeve
•
Align joiner/ender with aligner sleeves on starter and slide together. Be careful not to damage any wiring.
•
If necessary, lift both luminaires, then slide them together.
Option 2 - Mount to Structure
•
Mount to structure support with hardware appropriate for the
structure type.
•
NOTE: If installing a joiner luminaire, leave nut loose, allowing
luminaire to hang at an angle.
•
If there is no joiner/ender, then tighten nuts fully.
B. Join Luminaires
CAUTION
Once luminaires are aligned together,
joiner luminaire is not yet secure.
Ensure it does not slide off as it rests
on the starter luminaire.
CAUTION
DO NOT attempt to join
luminaires together on the floor.
Damage may result when lifted.
Follow these instructions.
1/4-20" Sealing Washer (provided)
1/4-20" Nut (by others)
Joiner/Ender
Aligner Sleeve
1/4"-20 Lag Bolt
(by others)
1/4"-20 Sealing Washer
(provided)
1/4"-20 Nut
(by others)
Mounting Option 1
Mounting Option 2
Threaded Rod
(by others)
1/4"-20 Sealing Washer
(provided)
