Installation Instructions
LSCU
11
3.
If desired, break the LeverLock™ backplanes (T) along the
scored mid-line. (See Figure 13)
Figure 13
WARNING
:
Exceeding the weight capacity can
result in instability, causing the cart to tip over resulting in death
or serious injury! The Lever Lock™ backplanes have a
separate weight limit of 10 lbs (4.5 kg). If the Lever Lock™
backplane is separated, each half backplane has a weight limit
of 5 lbs (2.26 kg).
4.
Attach components to Lever Lock™ backplanes (T)
following component manufacturer’s instructions.
(mounting hardware not included)
Cable Management
1.
Route cables from display through top holes on cart as
desired. (See Figure 14)
2.
Use cable covers (L) to secure cables to side of cart as
desired.(See Figure 14)
Figure 14
3.
Route cables through lower holes on cart as desired. (See
Figure 14)
Covers Installation
NOTE:
Before installing any cover, make sure the handle is in
the "unlocked" position (to the left) before installing to
cart. (See Figure 15)
Figure 15
1.
Place large cover (S) in position to install by placing lower
edge along slot that holds cover. (See Figure 16)
2.
Press large cover (S) against cart until it is flush with cart
and is secured in position. (See Figure 16)
3.
Slide handle to locked position. (See Figure 16)
4.
Place small cover (R) in position to install by placing lower
edge along slot that holds cover. (See Figure 16)
5.
Press small cover (R) against cart until it is flush with the
cart and is secured in position, (See Figure 16)
6.
Slide handle to locked position. (See Figure 16)
Figure 16
Mid-line
3
1
1
(L) x 2
2
2
3
3
"unlocked position"
4
5
5
1
2
2
(S)
3
6