LEGRAND 430 523, User Manual

Page: 32 / 91

CHECK POINTS BEFORE OPERATION
Before turning on the system, check if the wire(s) and cable(s) are connected properly. •
Check if the camera ID on the controller is properly selected. The camera ID must be identical to that of the •
target camera. The camera ID can be checked by reading the DIP switch of the camera or on OSD.
If your controller supports multi-protocols, the protocol must be changed to match to that of the camera. •
Adjust the DIP switch after turning off the camera. If you changed the camera protocol by changing the DIP •
S/W, the change will be effective after you reboot the camera.
Since the operation method can be different by controllers, refer to your controller manual if the camera can •
not be controlled properly. The operation of this manual is based on the standard Pelco® Controller.
32