12
Installation
Connect a DC motor to PCB terminals A1 and A2 as shown in
Figure 7, page 13.
Ensure that the motor voltage rating is
consistent with the drive’s output voltage.
Power input
Warning
This drive is not diode-protected from reverse battery voltage.
You must assure that POS (+) is wired to +VDC IN and NEG
(–) is wired to –VDC IN.
Connect the DC power leads to ter VDC IN and - VDC IN,
or to a single-throw, single-pole master power switch as shown in
Figure 7, page 13 (recommended).
Fuse
Wire a power input fuse between the stop switch (if installed) and
the + VDC IN terminal on the circuit board. The fuse should be
rated at 150% of input voltage and 150 - 200% of maximum motor
nameplate current.
Motor
LEESON drives supply motor voltage from A1 and A2 terminals. It
is assumed throughout this manual that, when A1 is positive with
respect to A2, the motor will rotate clockwise (CW) while looking at
the output shaft protruding from the front of the motor. If this is
opposite of the desired rotation, simply reverse the wiring of A1 and
A2.
Summary of Contents for 175290.00
Page 42: ...36 Notes ...
