[3]
Storage and Unpacking
Storage:
The Vending Machine should be stored and
transported in an upright position. If the Vending
Machine is tilted beyond 45 degrees of vertical, oil
may drain from the compressor casing. Should this
occur, it’s recommended that the Vending Machine
be returned to a vertical position for at least 1 hour
before energizing the unit. This will allow oil that
may have migrated out of the casing an opportunity
to drain back to the compressor.
Unpacking:
Prior to installation, the outer packaging on the
Vending Machine will need to be removed. The
majority of the packaging materials can be recycled
and disposed of in an environmentally friendly
manner. The wooden skid is secured to the
Vending Machine with hex-headed screws and will
require the use of a 3/8" hex-socket for screw
removal.
Vending Machine Pallet Removal:
1.
First remove two screws from each side
perimeter board using a long 3/8” hex-
socket.
2.
Remove the six Philips screws from the
front perimeter board and remove board.
3.
Remove two Philips screws from the left or
right side. This will remove the skid footing
to aid in use of pallet jack.
4.
Insert pallet jack from the front side.
CAUTION: Stay clear of the load cells.
5.
Use lifting device to lift the unit high
enough to remove pallet and the orange
pallet cushions from the back.
6.
Slide unit off of the pallet jack into position
on a sturdy level surface. Use stackers
included if needed.
Summary of Contents for VM40
Page 10: ... 10 Wiring Diagram ...
