LeeBoy 8616B, Operation, Service And Parts Manual

Page: 79 / 287

LeeBoy 8616B Conveyor Paver 5-6
ROUTINE MAINTENANCE
Preparing Machine for
Maintenance
1. Park the paver on a flat surface.
2. Lower all attachments to ground level.
3. Place joysticks in neutral.
4. Run engine at 1/2 speed (RPMs) without load for
three to five minutes.
5. Reduce engine speed (RPMs) to slow idle.
6. Place ignition switch in the OFF position.
If any maintenance must be
performed while the engine is running, DO NOT leave
paver unattended.
Every 10 Hours or Daily Routine
Maintenance
1. Scrape off paving material and spray cleaning
solvent or release agent on the wearplate,
extensions, and any other area that has been in
contact with the paving material. Cleaning should
be performed while the paver is hot.
2. Remove any debris from screed and check for
leaks.
3. Lubricate the required parts. (Pages 5-4 and 5-5)
4. Check light bulbs and replace if needed.
5. Check battery cables and connections.
6. Check coolant level. Fill if needed.
7. Check for loose, worn or damaged hoses, tubes
clamps. Tighten, repair or replace promptly.
8. Keep the fuel tank full to prevent condensation.
Always fill at the end of the day.
9. Check engine oil level. (Page 5-17)
10. Check hydraulic oil level. (Page 5-19)
11. Perform any other engine preventive maintenance
described in the Engine Operator’s Manual.
Every 50 Hours or Weekly
Routine Maintenance
1. Check air filter. (Page 5-18)
2. The FIRST 50 HOURS, change engine oil and filters,
then every 250 hours thereafter. (Page 5-17)
3. Check all battery connections and remove any
corrosion present.
4. Check torque hub oil level. Refille if needed. (Page
5-5)
5. Lubricate grease fittings on the flight screw on both
sides of the screed, the fitting on the depth screw,
and the fittings on the flange bearings located on top
of the extension screed. Grease nuts on extension
screws.
(Pages 5-4 and 5-5)
6. Perform previous routine maintenance and any
other engine preventive maintenance described in
the Engine Operator’s Manual.
Every 100 Hour or Monthly
Maintenance
1. Check main engine belt. Replace if needed.
2. Check and adjust conveyor drive chains.
(Page
5-8)
3. Check and adjust conveyor flight chains. (Page 5-7)
4. Check auger drive chains, lubricate and adjust.
(Page 5-9)
5. Check and adjust screed extension top guide.
(Page 5-9)
6. Perform previous routine maintenance and any
other engine preventive maintenance described in
the Engine Operator’s Manual.