4.3 MOUNTING & LAMINATING POUCHES
When ready to laminate & mount, please follow these easy steps:
1.
Turn on your machine by pressing the ON SWITCH.
2.
Set to recommended temperature of 350 degrees.
3. Allow the machine to heat for approximately 35-45 minutes.
4. Check item to be mounted and laminated to make sure there are no foreign par-
ticles on the surface.
5. Place laminating pouch on flat surface and insert item to be mounted and lami-
nated between the film and board. Make sure item is square to edges of board.
6.
SET MACHINE GAP OPENING TO THE THICKNESS OF THE MOUNTING
BOARD (example 3/16” board = 3/16” gap) by pulling out Gap Knob on right side of
machine and turning to the proper setting (Pull out to set and then push in to hold).
7.
Insert board into laminator (sealed edge FIRST) making sure the film is flat on
the item.
8.
The board will be laminated at a speed of one foot per minute.
9.
Remove board from laminator as soon as it is ejected from machine.
10. Lay on flat surface until cool to touch.
13
Summary of Contents for 44" Pouch
Page 17: ...NOTES 16 ...
