4.0 SETUP & OPERATION
This section explains in detail the setup and operation of your pouch laminator.
4.1 WARM UP TO OPERATING TEMPERATURE
1.
Remove machine from shipping container and place in work area.
2.
Plug the machine into proper outlet.
3.
110v standard 44”
110v 15amp
NEMA 5-15R
220v standard 44”
220v 15amp
NEMA L6-20R
4.
Turn on main power switch.
5.
Set roll height adjusting knob to desired thickness of material to laminate.
6.
Set to recommended temperature of 350 degrees.
7.
Wait 30 minutes for machine to warm up to operating temperature.
4.2 POUCH LAMINATING
You will need a proper sized mounting sled (flat board used to carry pouch through
laminator while keeping it flat and smooth), and the proper sized pouch.
Pouch size
Sled size
18.5” x 24.5”
21” x 28”
25” x 37”
27” x 40”
37” x 49”
40” x 52”
When ready to laminate, please follow these easy steps:
1.
Turn on your machine by pressing the ON SWITCH.
2.
Set to recommended temperature of 350 degrees.
3.
Allow the machine to heat for approximately 20-30 minutes.
4.
Check sled to make sure there are no foreign particles on the surface.
5.
Lay your sled on flat surface with foam side up.
6.
Lay your pouch on the sled with sealed edge of pouch toward the front of the
sled.
11
Summary of Contents for 44" Pouch
Page 17: ...NOTES 16 ...
