www.ledneonflex.com
www.GLLS.com
6
Safety/Warnings
Correct
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Incorrect
• Before making any cuts, installation,
maintenance or connection, be sure the fixture is
disconnected!
• Note: all connectors must be assembled correctly
to achieve IP67 rating.
• Fixture’s rated voltage must match that of the
power supply.
• Power supply must be constant voltage.
• Incorrectly cutting this product will damage the
fixture.
• Do not power the light for over 30 minutes in coil
packaging.
• Do not bend past the minimum diameter (Fig. 1)
or twist this fixture (Fig. 3, 5). Doing so will result
in damaging the internal circuit board.
• Do not bend the fixture in the opposite direction
of its specified bending direction (Fig. 2, 4).
Doing so will damage the internal circuit board.
• Do not operate all channels of color changing
fixtures simultaneously at full capacity for
extended periods of time.
• Do not put undue stress or pull excessively on
the cables or injection connectors. This can cause
the connectors to detach or fail. (see page 24-27)
• To extend the life of your fixtures, do not operate
lights in daylight temperatures exceeding 140°F
(60°C). Doing so will decrease the lifespan of the
LEDs.
