Led Lenser®
*
EN Operating instructions P6X_V.01 | 7/31/2014
15
5.7 Attaching the Wrist Strap
The included wrist strap may be attached to the end cap.
1. Feed the thin loop ③ of the wrist strap through the
attachment ring ② on the end cap ① of the flashlight.
2. Feed the thick loop ④ through the thin loop ③ and pull
the thick loop ④ until the thin loop ③ has tightened on
the ring ②.
5.8 Attaching the Belt Bag
The belt bag may be attached using the snap-hook or to a belt
up to a width of 80 mm.
1. Open the snap-hook by pushing in and clipping the hook
to, for example, the belt.
or
2. Open the stud on the belt holder.
3. Remove the belt holder (hook and loop fastening)
4. Slide the belt holder behind your belt and secure onto the
belt bag again.
5. Secure the belt holder by closing the stud.
5.9 Putting the Flashlight into the Belt Bag
1. Undo the hook and loop of the belt bag.
2. Slide the flashlight with the end cap first into the belt bag
as far as it will go.
3. Close the hook and loop of the belt bag.
5.10 Automated Functions
5.10.1 Temperature Monitoring
The P6X is fitted with a temperature monitoring function
(electronic regulation with temperature sensor). This prevents
the flashlight from overheating when in use. This may result in
a reduction in brightness as soon as the function is activated.
→
If necessary, switch off the flashlight and allow to cool
down.
5.10.2 Battery State Warning
A low charge state of the batteries is signalized by 3 brief
flashes of the LED. The flashing is repeated every 15 seconds
until the flashlight switches itself off automatically after 10
minutes.
→
Change the batteries as described in chapter 5.5.
5.11 Cleaning
The following should be noted for cleaning:
•
Clean the flashlight and its accessories only dry using a
lint-free cloth.
•
If the flashlight comes into contact with salt water,
remove the salt water immediately and fully with a lint-
free cloth.
3
4
2
1
5. Operation
